Replacing fuses
65
To replace a main fuse:
1. Switch off the lamp, allow the luminaire to cool
with fans running for 20 minutes, then isolate it
from AC power and ensure that power cannot be
reconnected accidentally.
2. Remove the rear cover plate as described in
3.1.4: Connections compartment access"
3. The two main fuses are located in fuseholders in
the connections compartment. Use a torx
screwdriver to open the fuseholders and remove
the fuses.
4. Replace the defective fuse with one of the same
size and rating. Replace the fuseholders.
5. Reinstall the cover plate as described in "
Connections compartment access"
If neither of the main fuses are defective, check and if necessary replace the 10 amp slow
blow main PCB low-voltage fuse (P/N 05020025) with one of the same type and rating.
50
60
277
250
240
230
220
208
200
Hz Setting
Volt Setting
Volt Setting
SERVICE
DMX
OUT
DMX
IN
1
2 3 4 5 6
Ground
Neutral
Live
1
Live
1
Live
2
Live
2
MAINS
MAIN
FUSE
PCB
Live 2
Live 2
Fuse
Live 1
Live 1
Fuse
Main fuses
Main PCB fuse
Figure 23: Fuses
Summary of Contents for Exterior 1200 Wash
