5 . 1 . 1 S e t t i n g u p a l u m i n a i r e w i t h a P C a n d M U M
Using MUM, you can connect to and set up one luminaire at a time. Refer to the MUM user
manual for instructions on installing and starting the MUM application.
Connecting a PC with MUM
To connect a PC with MUM to an Exterior 1200 Wash:
1. Obtain the MUM application, a DABS1 adaptor and interface cables. These are available as
a set from Martin Architectural, P/N 90758090.
2. Connect the DABS1 adaptor to your PC using the USB cable.
3. Connect the DABS1 adaptor to the Exterior 1200 Wash using either an XLR connector
connected to the data link or the RJ-45 service socket in the connections compartment
behind the rear cover plate. If connecting via the data link, note that you may only connect
to one luminaire at a time.
4. Apply power to the Exterior 1200 Wash and start the MUM application. The application will
automatically detect an Exterior 1200 Wash if it is powered on and correctly connected. It
will also retrieve information and current settings from the luminaire and display them.
PC
DABS1
Exterior 1200
Figure 13: Connecting to a PC with MUM
Summary of Contents for Exterior 1200 Wash
