Lamp maintenance
63
3. See Figure 19. Loosen
the locking screws in the
sliders on each side at
the front of the housing.
4. Slide the lamp/effects
module out of the
housing, avoiding strain
on internal wiring. Note
that a lamp cutout
mechanism is activated
as soon as the module is
moved from its normal
position.
5. See Figure 20. Flip open the latch plate to lock the module in the out position.
6. See Figure 21. The lampholder is
at the rear of the effects modules.
Loosen, but do not remove, the
three Allen screws (arrowed)
holding the lampholder. To
release the lampholder, push it in
slightly towards the modules and
rotate it so that the holes in the
lampholder plate clear the Allen
screws, then gently pull the
lampholder clear. Avoid touching
or knocking the lamp against
other components.
Figure 19: Slider locking screws
Latch plate
Figure 20: Slider latch plate
Figure 21: Lampholder screws
Summary of Contents for Exterior 1200 Wash
