46
Exterior 1200 Wash user manual
The following options are available:
When setting scene fade and scene wait times for luminaires in synchronized operation,
avoid unexpected problems by making sure that each scene time is slightly longer in the
master luminaire than in the slave luminaires (see "
6.1.2: Synchronized operation with
on page 40 for full details).
Scene management
Once you have specified a mix of effects, you can store the scene using the options
available under the Program menu:
When the program is run, scenes execute in a continuous, ascending loop.
Note that, if a “slave” luminaire has:
• Fewer scenes than the master luminaire, it will run these in a cycle continuously, until the
master luminaire signals that the program should start from the beginning again.
Intensity
The dimmer provides smooth, high-resolution 0 - 100%
dimming.
Cyan
Magenta
Yellow
The CMY color mixing system is based on graduated cyan,
magenta, and yellow color filters. A full spectrum of colors can
be achieved by varying the amount of each filter from 0 to
100%.
Note that mixing 3 colors results in loss of light - the light is
blacked out when all 3 colors are fully applied. For maximum
brightness, mix only 2 colors at a time.
Zoom
The lens can be driven forwards or backwards to vary the size
of the beam.
Filter color
buttons
Clicking on the five square colored buttons selects positions on
the color wheel. The color wheel has red, green, and blue
dichroic color filters, a 5600K to 3400K dichroic color correction
filter and an open (white) position. It can be used together with
CMY color mixing to increase color saturation.
Scene fade
time
The fade time, anything from 0 to 120 seconds, is the time it
takes to change from one effect to another.
Scene wait
time
This is the duration a color is applied. A wait time can be from 1
second to 12 hours.
Store scene
Save settings in the current scene.
Add scene
Save settings in a new scene at the end of the current
sequence of scenes.
Insert scene
Save settings in a new scene before the current scene.
Tip:
Think of the Add and Insert commands as Save commands, to
be used as the last step after programming all effects.
Delete
scene
Remove the current scene from memory. Scenes after the
deleted scene are renumbered.
Next scene
Step to the next scene.
Previous
scene
Step to the previous scene.
Delete all
Remove all scenes from the luminaire memory.
Run
program
Run the scenes in the programmed light show.
Summary of Contents for Exterior 1200 Wash
