Preparing for DMX control
51
DMX addressing with a DAD
To set a DMX address using a DAD, follow the instructions in the DAD user manual. The
DAD can only set the DMX address on one luminaire at a time, and must be connected to
one luminaire only via the data link.
7 . 1 . 2 D M X L a m p O f f o p t i o n
When the DMX Lamp Off feature is ON (the default setting), lamp power can be turned off
from the controller by setting channel 1 to a DMX value from 248 to 255 (97-100%). When
set to OFF, the Lamp Off command executes only if channels 3, 4, and 5 are set to values
from 230 to 232. Bear in mind that if you turn a lamp off, you must allow it to cool for eight
minutes before you can restrike it.
7 . 1 . 3 D M X R e s e t o p t i o n
When the DMX Reset feature is ON (the default setting), the luminaire can be reset from
the controller by setting channel 1 to a DMX value from 208 to 217 (81-85%). When DMX
Reset is set to OFF, the reset command executes only if channels 3, 4, and 5 are set to
values from 230 to 232.
Summary of Contents for Exterior 1200 Wash
