IMPORTANT:
Read carefully before installing fixture. Retain
for future reference.
WARNING
Risk of Electrical Shock! Disconnect power at fuse or
circuit breaker before installing or servicing.
WARNING
Risk of Fire! Do not install insulation within 76 mm
(3 in) of any part of the luminaire or in a way that may
entrap heat.
WARNING
To prevent wiring damage or abrasion, do not expose
wiring to edges of sheet metal or other sharp objects.
WARNING
Installation and servicing to be performed only
by qualified personnel, if not qualified, consult an
electrician.
WARNING
Do not energize the LED Engine until the protective
covering has been removed and the lower trim
properly installed. Do not touch the yellow surface of
the LED as it may damage the light engine.
INS #
IB520052EN
Installation Instructions – LDRT8B/LDRT812B Recessed LED
Retrofit
Instructions d’installation – LDRT8B/LDRT812B LED Retrofit
encastré
Instrucciones de instalación de las luminarias LED adaptadoras,
empotradas y de uso LDRT8B/LDRT812B
otee:
N
This fixture should be supported by main runners or
other structure that is capable of supporting fixture
weight of 30 Ibs.
SAFETY:
When using electrical equipment, basic safety
precautions should always be followed, including the
following:
1. This unit is for recessed mounting only. Do not use in
hazardous locations nor near gas or electric heaters.
2. Do not use this equipment for other than the intended
use.
3. Install only in accordance with National Electrical Code
and local regulatory agencies’ requirements.
4. Install this kit only in luminaires that have the
construction features and dimensions shown in the
photographs and/or drawings.
5. Installation of this retrofit assembly requires a person
familiar with the construction and operation of the
luminaire’s electrical system and the hazard involved.
If not qualified, do not attempt installation. Contact a
qualified electrician.
6. Do not alter, relocate, or remove wiring, lampholders,
power supply, or any other electrical component
unless specifically mentioned in these instructions or
shown in the included photographs and/or drawings.
7. Only those open holes indicated in the photographs
and/or drawings may be made or altered as a result of
kit installation. Do not leave any other open holes in
an enclosure of wiring or electrical components.
TM
