![background image](http://html1.mh-extra.com/html/mandik/climatix/climatix_operating-instructions-manual_4004498044.webp)
KJM MANDÍK
–
Detailed operating instructions
M&C KJMPNO 07/2022
MANDÍK, a.s.,
44
TempOut
–
condensing unit operation is blocked from the outdoor temperature
MinOutdoorCool
and
MinOutdoorHeat
.
NoCool
– cooling by the condensing unit is blocked in the winter
(
BlockSummerWinter
=
Yes
).
NoHeat
– heating by the condensing unit is blocked in the summer
(
BlockSummerWinter
=
Yes
).
Defrost
–
condensing unit is defrosting.
Err
–
condensing unit signals a fault.
Power
(%) – current heating or cooling capacity of the condensing unit.
Compressor
(
On/Off
) – current compressor demand of the condensing unit.
ControlTemperature
(
Room
/
Extract
/
Supply
/
Preheat
)
– selects the temperature control
temperature per which the required heating or cooling capacity will be calculated.
MinPower
(1%)
– minimum power to turn on the condensing unit. For Mitsubishi units with
PAC_IF
control, this value must be set to 18%.
MaxPower
(100%)
– limitation of the maximum power of the condensing unit. This function
can be used, for example, for oversized power or for special condensing unit control modules.
Standby
(1.5V)
– intended for Mitsubishi units with
PAC_IF
control. At this control voltage
value, the condensing unit is in its standby regime and has zero power.
StandbyOff
(10 min)
– intended for Mitsubishi units with
PAC_IF
control. It defines the
amount of time the condensing unit is in standby regime before it shuts down completely.
MinOutdoorCool
(10 °C)
– minimum outdoor air temperature at which the condensing unit
can still cool effectively. This parameter is usually specified by the manufacturer in the
condensing unit documentation.
MinOutdoorHeat
(-10 °C)
– minimum outdoor air temperature at which the condensing unit
can still effectively heat. This parameter is usually specified by the manufacturer in the
condensing unit documentation.
BlockSummerWinter
(
No
/
Yes
)
– this parameter blocks heating by the condensing unit in
summer and cooling by the condensing unit in the winter. The current temperature period is
specified in
TemperatureRegulation
.
DelayOff
(
Normal
/
Recup
)
– this parameter allows the condensing unit to shut down after the
recuperation has shut down.