MCP-601 Operator’s Manual
Magni Systems, Inc.
54
•
Analog Input
This is the analog input graphics conversion, or key and video overlay
mode. SDI and analog outputs are always genlock to the selected analog
input.
Genlock Bandwidth: Select analog input bandwidth and genlock filter mode:
Broadcast*
Setup for full bandwidth studio video signals that are relatively stable.
VTR
Setup for signals from VTR that have horizontal to subcarrier timing
variations.
TV
Setup for off-air signals that have both noise and timing variations.
CUTOUT: Sets the size of the graphics cutout in the reduced size video.
Offsets: Set the graphics cutout size to overlay the blanking area of incoming video so that
black or vertical interval signals will not show on the output picture while allowing
maximum video picture size. There are four offset settings:
Offset Left and Offset Right, defined the number of pixels from the picture edge.
Offset Top and Offset Bottom, defined the horizontal lines from the picture edge.
SERIAL PORT: Settings for serial communication port
Handshaking
Xon/Xoff
NONE*
Baud Rate
9600, 19200, 28800, 38400, 57600, 115200*
SYSTEM IDS: Indicates the revision and date codes of the firmware.
Loader
Software
Alex
Babel
Hardware
Hardware ID identifies the product model
Serial Number
Serial number of the unit.
Recommendation for MENU Operational Settings:
DISPLAYS, Filters, Flicker, Reduced
DISPLAYS, Filters, Horizontal, On
DISPLAYS, VGA Only, AutoPos Enable, ON
INPUT VIDEO, No Input, Default STD, NTSC or PAL depends on TV standard.
INPUT VIDEO, No Input, Genlock Source, REF
INPUT VIDEO, SDI Input, Genlock Phase, REF
INPUT VIDEO, Analog Input, Genlock Bandwidth, Broadcast or VTR or TV depends on the
facility setup.