MacDon R113 SP, Operator'S Manual

Page: 58 / 240

215009
44
Revision A
1021540
A
B
C
D
E
Figure 3.55: M1170 Hydraulic and Electrical
Connections
7. For M1170: Connect hydraulic hoses and electrical harness
to receptacles on windrower as follows:
a. Connect pressure hose to receptacle (A).
b. Connect return hose to receptacle (B).
c. Connect case drain hose to receptacle (C).
d. Connect the electrical harness to receptacle (D).
NOTE:
The hydraulic hoses should have enough slack to pass
by the multicoupler (E) without coming into contact
with it. This will protect the hoses from rubbing against
the multicoupler and becoming damaged. You can
increase slack in the hoses by loosening and adjusting
the hose holder on the front windrower leg, and pulling
the hoses backward toward the windrower.
1027209
A
B
C
D
E
Figure 3.56: M1240 Hydraulic and Electrical
Connections (Draper Ready Configuration)
8. For M1240: Connect hydraulic hoses and electrical harness
to receptacles on windrower as follows:
a. Connect pressure hose to receptacle (A).
b. Connect return hose to receptacle (B).
c. Connect case drain hose non-flat face coupler to
receptacle (C).
NOTE:
The R113 SP when attached to M1240 requires a
different set of low pressure case drain couplers with a
different hose connection to the hydraulic tank.
d. Connect the electrical harness to receptacle (D).
NOTE:
The hydraulic hoses should have enough slack to pass
by the multicoupler (E) without coming into contact
with it. This will protect the hoses from rubbing against
the multicoupler and becoming damaged. You can
increase slack in the hoses by loosening and adjusting
the hose holder on the front windrower leg, and pulling
the hoses backward toward the windrower.
9. Close the windrower
’
s left side platform. Refer to windrower operator
’
s manual for procedure.
OPERATION