MacDon R113 SP, Operator'S Manual

Page: 115 / 240

215009
101
Revision A
CAUTION
Never start or move the machine until you are sure all bystanders have cleared the area.
10. Start the engine, and raise the header slightly.
11. Lower the header onto blocks, so the left end is slightly higher than the right end.
12. Shut down the engine, and remove the key from the ignition.
13. Add lubricant through the inspection hole used to check the oil level.
IMPORTANT:
Do NOT overfill the cutterbar. Overfilling can cause overheating, damage, or failure of cutterbar components.
NOTE:
Refer to the inside back cover of this manual for lubricant specifications.
14. Recheck oil level.
1004033
A
B
Figure 4.12: Cutterbar Oil Inspection Plug
15. Check O-ring (B) for breaks or cracks, and replace if
necessary.
16. Install plug (A) and O-ring (B). Tighten securely.
1021476
A
Figure 4.13: Cutterbar Doors
17. Close cutterbar doors (A). For instructions, refer to 3.7.3
Closing Cutterbar Doors, page 66 .
MAINTENANCE AND SERVICING