MacDon R113 SP, Operator'S Manual

Page: 51 / 240

215009
37
Revision A
3.4.3 Attaching R113 SP to M155 or M155 E4 SP Windrower
–
Hydraulic Center-Link
without Optional Self-Alignment
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1. Shut down the engine, and remove the key from the
ignition.
1021748
A
B
C
Figure 3.37: Header Support
2. Remove hairpin (B) from clevis pin (A), and then remove
clevis pin from header support (C) on both sides of the
header.
1029714
A
B
Figure 3.38: Header Float Linkage
IMPORTANT:
To prevent damage to the lift system when lowering header
lift linkages without a header or weight box attached to the
windrower, ensure the float engagement pin is installed in
storage position (B) and
NOT in engaged position (A).
3. To disengage float springs, move the float engagement pin
from engaged position (A) and insert pin into storage
hole (B). Secure float engagement pin with lynch pin.
Repeat for opposite linkage.
OPERATION