MacDon HC10, Original Instruction

Page: 63 / 242

215126
41
Revision A
3.9 Installing the Forming Shield
To install the forming shield, follow these steps:
1002929
A
B
Figure 3.60: Forming Shield
1. Position the forward end of forming shield (A) onto two
pins (B) located on the rear cover of the conditioner.
1002927
A
Figure 3.61: Lynch Pin
2. Insert lynch pins (A) to secure forming shield to conditioner.
1005122
A
B
C
D
Figure 3.62: Forming Shield
3. Set forming shield side deflectors to desired width by
loosening handle (A) and moving deflector (B). Set
deflectors on both sides to approximately the same
position.
4. Tighten handles (A).
5. Loosen handles (C) and adjust fluffer shield (D) to middle
position.
6. Tighten handles (C).
UNLOADING AND ASSEMBLY