Enclosure and Component Installation
Mounting the enclosure on a pole
The Stinger® Compact Remote ATM DSLAM Getting Started Guide
3
-11
12
Align the two holes on each side of the chassis with the holes in the pole
mounting hardware and install the bolts to secure the chassis on the mounting
hardware.
Side-mounting the enclosure on a pole
The exterior ventilation covers on each side of the chassis have mount points and can
also serve as side mounting brackets for the chassis. Follow all local safety practices
and guidelines and use the following general procedure to mount the enclosure.
1
Use a 9/16 in. combination wrench or socket with a 6 in. extension and handle to
loosen the two nuts that secure the lag bolt tabs on the top and bottom mounting
brackets. The top bracket is shown in Figure 3-6 on page 3-8.
2
Mark the location of the top mounting bolt hole in the center of the pole, at least
67 inches (1.7 meters) above the ground. Use an 11/16in. drill bit, or a drill bit
that is 0.625in. to 0.7in. (15.875mm to 17.78mm) in diameter, to drill the hole
for the top mounting bolt through the center of the pole.
3
If a rear mount bracket is available, use the top mounting bolt to temporarily
install it and the pole mounting brackets, as shown in Figure 3-7 on page 3-9.
Allow the hardware to hang vertically and mark the location for the lower
mounting bolt on the pole.
Note
If a rear mount bracket is not available, mark the location for the center of
the lower mounting bolt hole exactly 24.0 inches below the center of the top bolt
hole.
4
Mount the upper and lower pole mounting brackets, using the top and bottom
mounting bolts.
Note
The threaded end of the bolt should extend at least 1 inch beyond the back
of the pole.
5
Place washers and nuts on the threaded ends of the two bolt ends and use a
15/16in. combination wrench to tighten the nuts until the washers begin to
become concave into the pole.
Note
While tightening the nut on the threaded end of the bolt, hold the bolt
head with a 15/16in. socket with a 2in. extension (min.) and handle.
6
Slide the lag bolt tabs on each of the mounting brackets so that the tabs are in
contact with the pole. Then use a 9/16in. socket to tighten the two nuts on each
mounting bracket that hold the lag bolt tabs in place (see Figure 3-6 on
page 3-8).
7
Of the three lag bolt holes, select the one that is in direct contact with the pole.
Drill into the pole through this lag bolt hole to a depth of at least 4 inches with a
5/16in. drill bit. Or, you can use a drill bit with the smallest diameter between
0.3in. and 0.4in. that allows the lag bolts to be threaded into the pole without
excessive force.
8
Install the lag bolts with a 5/16in wrench.
9
Carefully lay the Stinger Compact Remote chassis onto its side so that the side
that will be mounted against the pole is facing up. Remove the side mounting
bracket from this side.
