Hosted System Configuration
Working with the
remote-shelf-config
profile
The Stinger® Compact Remote ATM DSLAM Getting Started Guide
5-11
Upstream traffic shaping in a hosted system
The system shapes traffic in the transmit output direction at the maximum line rate
of the host trunk port and at the maximum line rate of each optical interface of every
remote COP in the hosted system. The line rate is not configurable for these
interfaces. Virtual path shaping, which enables traffic shaping control on a per-VPI
basis, can be configured and applied only at the host trunk ports.
For OLIM interfaces and LIM interfaces in the host, and RLIM interfaces in remote
shelves, the
allow-max-up-stream-bandwidth
setting provides a configurable
maximum line rate for upstream traffic.
Internal queue priorities on an OLIM
With this software version, the queueing mechanisms of both the remote COPs and
the OLIM are internal. The system provides non-configurable default queues to
maintain priority and preferred scheduling as appropriate for different traffic classes
(CBR, rtVBR, and so forth).
Note
The system creates
switch-config
profiles for each OLIM installed in the
system. However, these profiles are read-only for the OLIM queues and shaping
configurations.
LIM-trunk VP switching capacity via an OLIM
Up to a total of 59 LIM-to-trunk virtual path connections can be supported through
an OLIM.
Working with the
remote-shelf-config
profile
The
remote-shelf-config
profile resides on the host for enabling control channel
communications to remote shelves and (optionally) shelf validation. To identify a
remote shelf as part of the hosted system, you must create a
remote-shelf-config
profile and assign a shelf ID that is unique within the system. For example:
HOST>
new remote-shelf-config shelf-3
HOST>
list
[in REMOTE-SHELF-CONFIG/shelf-3 (new)]
remote-shelf-id* = shelf-3
host-port = { { shelf-1 any-slot 0 } 0 }
name = ""
location = ""
nailed-group-bin = 3
enabled = no
remote-shelf-type = stngr-cr-3
validation-config = { yes 0 }
Overview of profile contents
Following are the parameters, shown with default settings, for enabling a remote
shelf:
[in REMOTE-SHELF-CONFIG/""]
remote-shelf-id* = any-shelf
host-port = { { shelf-1 any-slot 0 } 0 }