Hosted System Configuration
Working with the
remote-shelf-config
profile
The Stinger® Compact Remote ATM DSLAM Getting Started Guide
5-15
The following commands set the host to validate this shelf this shelf with the number
(192) that has been configured separately on the Stinger CR DIP switch:
HOST>
read remote-shelf-config shelf-3
HOST>
set validation-config validation-id = 192
HOST>
write -f
This validation setting on the host Stinger is applied when the corresponding hosted
Stinger CR ATM DSLAM unit is reset and the control link to the host unit is
reestablished.
Caution
Resetting the hosted Stinger unit will interrupt any traffic on the unit while
it is restarting.
You may reset a hosted stinger unit with the
reset
command (see “R
hosted systems” on page 6-3). The command shown in the following example will
reset a hosted unit that is designated as shelf 3.
HOST>
reset -s 3