Initial Stand-alone Configuration
Administrative connections
The Stinger® Compact Remote ATM DSLAM Getting Started Guide
4-3
network connection from the Stinger CR ATM DSLAM unit to the management
workstation.
Note
Although an IP2000 module is depicted, the same connection is made to a
control module in the same way. For connector details, see “Control module
interfaces” on page 2-8, and “IP2000 interfaces” on page 2-10.
Figure 4-2. 10/100 Ethernet connection
To connect a management workstation to the Stinger CR ATM DSLAM unit using an
indirect Ethernet connection:
1
Connect one end of the Ethernet cable to the Ethernet RJ-48 port on the IP2000 or control
module.
2
Connect the other end of the Ethernet cable to the local LAN.
3
Ensure that the management workstation has connectivity to the LAN on which the unit
resides.
4
Ensure the Ethernet transceivers are connected properly to the network.
Gigabit Ethernet connection to a workstation console
After the IP address for the Gigabit Ethernet port of a Stinger unit is configured, and
the unit is connected to a Gigabit Ethernet network, an administrative Telnet
connection can be established through the network. Figure 4-2 shows an Ethernet
network connection from the Stinger CR ATM DSLAM unit to the management
workstation.
LPM 1
LIM 1
LPM 2
LIM 2
LPM 3
LIM 3
COP
LPM 1
LIM 1
LPM 2
LIM 2
LPM 3
LIM 3
COP
COMP
COMPACT REMO
CT REMOTE
TE
COOLING UNIT
COOLING UNIT
ST
STATUS
TUS
INTERNAL
INTERNAL
EXTERNAL
EXTERNAL
RED - F
RED - FAUL
ULT
GREEN - A
GREEN - ACTIV
E
CTIVE
BLINKING GRE
EN - INITIALIZIN
G
BLINKING GREEN - INITIALIZING
COMP
COMPACT REMO
CT REMOTE PO
TE POWER SUPPL
WER SUPPL
Y
V.CHECK
.CHECK
-48V
-48V
0V
0V
ST
STATUS
TUS
PO
POWER INPUTS
WER INPUTS
-190V
-190V
+190V
+190V
LINK
ACT
10
100
ACT
LINK
Gig. E
Workstation
Ethernet port
Ethernet
port
Router
LINK
ACT
10
100
ACT
LINK
Gig. E