2-10
The Stinger® Compact Remote ATM DSLAM Getting Started Guide
Preparing to Install the Unit
Checking modules and chassis
Note
Units manufactured and equipped for stand-alone operation with an IP2000
module have a modified enclosure door. This door is manufactured with a 0.5 inch
(1.3cm) bulge in the door at the location of the fiber connector on the IP2000. This
bulge allows space for the curvilinear guide fiber cable to physically route the fiber
light guides downward (see Figure 2-3 on page 2-6 and Figure 3-24 on page 3-33).
IP2000 interfaces
Figure 2-6 shows the location of the Gigabit Ethernet port, 10/100 Ethernet port,
serial diagnostic port, alarm input port, and Personal Computer Memory Card
International Association (PCMCIA) slots on a control module for the Stinger
Compact Remote ATM DSLAM unit. Details about interfaces and hardware
specifications for the IP2000 module are contained in the
IP Control Modules
Configuration Guide
.
Figure 2-6. The IP2000 module
LINK
ACT
10
100
ACT
LINK
Gig. E
10/100 Ethernet port
PCMCIA slots
Diagnostic port
Alarm input port
Gigabit Ethernet port