Hosted System Configuration
Configuring a hosted Compact Remote ATM DSLAM system
The Stinger® Compact Remote ATM DSLAM Getting Started Guide
5-5
that include bootloader code” on page 6-3.) The upgrade instructions in the
release note for the new software version will contain additional details.
2
Enable master mode in the
system
profile. Following are the required commands:
HOST>
read system
HOST>
set shelf-controller-type = master
HOST>
write -f
The master controller is always shelf 1.
If the system has
remote-shelf-config
profiles for remote shelves, it prevents
you from changing the
shelf-controller-type
back to
standalone
. (To do so,
you must delete all
remote-shelf-config
profiles.)
3
Reset the system.
After a unit's
shelf-controller-type
has been changed, it must be reset for the
change to become effective.
Identifying the remote shelves
For each shelf you want to put into service, you need to create and enable a
remote-shelf-config
profile on the host system. The profiles are indexed by shelf ID,
and are also accessible via SNMP.
When you enable a
remote-shelf-config
profile for a Compact Remote ATM DSLAM
system, the
oc3-atm
profile for the associated OLIM port is automatically enabled as
well. The
enabled
setting in the
oc3-atm
profile for an OLIM is read-only, and reflects
the status of the
enabled
setting in the associated
remote-shelf-config
profile.
For example, the following steps show how to add a shelf identified as
shelf-7
,
which is connected to port 5 of an OLIM in the host’s slot 2:
1
Create a
remote-shelf-config
profile and assign it a unique shelf number.
HOST>
new remote-shelf-config
HOST>
set remote-shelf-id = shelf-7
2
Specify the OLIM port to which the remote shelf is connected.
HOST>
set host-port physical-address slot = slot-2
HOST>
set host-port physical-address item-number = 5
3
Enable the control channel to the remote shelf (and configure validation
checking if appropriate) and save the profile. For information about validation,
see “Configuring shelf validation” on page 5-13.
HOST>
set enabled = yes
HOST>
set validation-config validation-enable = no
HOST>
write -f
4
Verify that the control channel is active and the host sees the remote shelf.
It may take up to several minutes to establish an active control channel. When
the control channel becomes active, the
show
command output should include
the remote shelf. For example:
HOST>
show
Shelf 1 ( master ):
Controller { first-control-module } ( PRIMARY ):