Chapter 3 Operation
98
Center
Offset_Y
You can fine tune the position of the trained pattern
that you want CCD output. You can adjust it up and
down.
Tips:The green arrow aims the positive direction.
Center
Offset_X
You can fine tune the position of the trained pattern
that you want CCD output. You can adjust it left and
right.
Accept Thresh
The minimum limit for the CCD find the matched
pattern in the field of view.
Score
The score for the CCD find matched pattern.
Exposure (ms)
You can control the image acquire exposure time. The
setting value is from 0.016 to 1000. When you use a
lower exposure time, you have to input a higher LED
light.
Find region
scale
You can setup the find region area, the setting value
from 10 to 99.5.
3.8.2 Two Pattern Job
AutoCCD use CCD to find two marks in the material and calculate the
position difference and rotate angle. If these two marks are not the
same, then you can use this job. It works for two different patterns.
This job can also work for the single pattern.
Job Name : LTT_Pattern-2-200.job
Name
Descriptions
ModelReg_
1
ModelReg_
2
Press this button, you can train the pattern
that you want.
You can save the job setting as a <admin>
user. For <operator> user, the job setting can
not be saved.
