Chapter 3 Operation
Color Setup
The settings of
been sent. It is not necessary
driver before sending
Setting Pen
Indicates the color you want to modify.
Power
Indicates the present power for setting pen. Its range is between 0~100%.
Speed
Indicates the present speed for setting pen. Its range is between 0~100%.
PPI
Indicates the number of
they are 166, 200, 250, 333, 500, and 1000.
Color Control
There are two options:
settings are defined based on print driver
color settings are defined based on
Laser Tickle Setup
The laser tickle pre
laser threshold. Increasing tickle width beyond 1 µs
plasma to cause laser emission. By applying a laser tickle, the laser will respond
predictably to laser signal even when there is considerable “off” time between
applied pulses
.
It is recommended
a LTT technician.
Alignment Mode
This function is used for alignment of laser.
function unless instructed to by a LTT technician.
Tickle output
Indicates the power
Continuous
If this function is on and press , the laser tickle will emit continuously until
pressing again. If this function is off, the laser tickle emits only when you keep
pressing .
Fast move
If this function is on, you can move the carriage faster to nine position of
working table by using motion control keys.
64
settings of each color can be adjusted under this selection after the file has
not necessary to use because mostly all settings
sending the file.
Indicates the color you want to modify.
Indicates the present power for setting pen. Its range is between 0~100%.
Indicates the present speed for setting pen. Its range is between 0~100%.
Indicates the number of pulses per inch for setting pen. It has six options, and
they are 166, 200, 250, 333, 500, and 1000.
There are two options:
[by file]
and
[by panel]
.
[by file]
settings are defined based on print driver
for single file.
[by panel]
color settings are defined based on
[Color Setup]
for
all files.
Laser Tickle Setup
The laser tickle pre-ionizes the gas into a plasma state so that it is just below the
laser threshold. Increasing tickle width beyond 1 µs will add enough energy to the
plasma to cause laser emission. By applying a laser tickle, the laser will respond
predictably to laser signal even when there is considerable “off” time between
It is recommended
NOT
to change the settings unless instructed to by
a LTT technician.
Alignment Mode
This function is used for alignment of laser. It is recommended
function unless instructed to by a LTT technician.
Indicates the power for laser tickle. Its range is between 0~100%.
If this function is on and press , the laser tickle will emit continuously until
pressing again. If this function is off, the laser tickle emits only when you keep
If this function is on, you can move the carriage faster to nine position of
working table by using motion control keys.
selection after the file has
settings are defined in print
Indicates the present power for setting pen. Its range is between 0~100%.
Indicates the present speed for setting pen. Its range is between 0~100%.
pulses per inch for setting pen. It has six options, and
[by file]
means that the color
[by panel]
means that the
files.
ionizes the gas into a plasma state so that it is just below the
will add enough energy to the
plasma to cause laser emission. By applying a laser tickle, the laser will respond
predictably to laser signal even when there is considerable “off” time between
to change the settings unless instructed to by
It is recommended
NOT
to use this
for laser tickle. Its range is between 0~100%.
If this function is on and press , the laser tickle will emit continuously until
pressing again. If this function is off, the laser tickle emits only when you keep
If this function is on, you can move the carriage faster to nine position of
