ii
Safety instructions
Otherwise, you may get an electric shock due to high voltage
terminals or charged capacitor exposure.
n
Do not remove the cover except for periodic inspections or
wiring, even if the input power is not applied.
Otherwise, you may access the charged circuits and get an electric
shock.
n
Wiring and periodic inspections should be performed at least
10 minutes after disconnecting the input power and after
checking the DC link voltage is discharged with a meter
(below DC 30V).
Otherwise, you may get an electric shock.
n
Operate the switches with dry hands.
Otherwise, you may get an electric shock.
n
Do not use the cable when its insulating tube is damaged.
Otherwise, you may get an electric shock.
n
Do not subject the cables to scratches, excessive stress,
heavy loads or pinching.
Otherwise, you may get an electric shock.
CAUTION
n
Install the inverter on a non-flammable surface. Do not place
flammable material nearby.
Otherwise, fire could occur.
n
Disconnect the input power if the inverter gets damaged.
Otherwise, it could result in a secondary accident and fire.
n
After the input power is applied or removed, the inverter will
remain hot for a couple of minutes.
Otherwise, you may get bodily injuries such as skin-burn or damage.
n
Do not apply power to a damaged inverter or to an inverter
with parts missing even if the installation is complete.
Otherwise, electric shock could occur.
n
Do not allow lint, paper, wood chips, dust, metallic chips or