50
VPN
Linksys
•
Local/Remote Security Group Type:
IP Address: Allows only the IP address that is entered to build the VPN
tunnel.
Subnet:
Allows local computers in this subnet to connect to the VPN
tunnel.
IP Range:
Allows a range of IP addresses to use this tunnel. Input the
beginning IP and the ending IP of the range.
IPSec Setup
NOTE:
The configuration on the remote router should be the same as the local router.
Keying
Mode:
Manual: Choose if you want to configure a self-defined key
without negotiation. Encryption key and Authentication key
will be used to verify remote users.
IKE with Preshared Key: Authenticates remote users by a
pre-shared key, and negotiates the second key in phase 2.
IKE with Pre-shared Key is selected by default.
•
Manual mode
Be sure to enter the same settings when configuring the other end router for
this tunnel.
Incoming SPI:
Input a number between 100~ffffffff as SPI (Security
Parameter Index). SPI is an identification tag for an
IPSec association. The incoming SPI of this router
should be the same as the outgoing SPI at the other
end of the tunnel.
Outgoing SPI:
Input a hexadecimal number between 100~ffffffff as
SPI. The outgoing SPI of this router should be the same
as the incoming SPI at the other end of the tunnel.
Encryption:
DES or 3DES.
Authentication:
MD5 or SHA1.
Encryption Key:
Input 16 numbers for DES method or 48 numbers for
3DES method.
If you enter less than required values, zeroes will be
filled in to empty spaces.
Example: If you enter 12345678 for DES encryption,
the box will show “1234567800000000.”
Authentication
Key:
Enter 32 numbers for MD5 method or 40 numbers for
SHA1 encryption method.
•
IKE with Preshared Key
Be sure to enter the same settings when configuring the other end router for
this tunnel.
Summary of Contents for LRT214
Page 1: ...LRT214 LRT224 User Guide ...
Page 33: ...29 DHCP Linksys ...
