Lenovo ThinkStation P910, Hardware Maintenance Manual

Page: 157 / 244

6. Slide the bracket together with the installed storage drive into the hard-disk-drive bay until the bracket
snaps into position.
Figure 94. Installing the hard-disk-drive bracket
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 213.
2.5-inch storage drive
Note: Depending on your computer model, a 2.5-inch hard disk drive or a 2.5-inch solid-state drive might
come with your computer.
To install or replace a 2.5-inch storage drive, refer to one of the following topics:
• “Installing or replacing a 2.5-inch storage drive in a hard-disk-drive bay” on page 151
• “Installing or replacing a 2.5-inch storage drive with a converter in a hard-disk-drive bay” on page 153
Installing or replacing a 2.5-inch storage drive in a hard-disk-drive bay
Attention:
Do not open your computer or attempt any repair before reading and understanding the Chapter
1 “Read this first: Important safety information” on page 1.
To install or replace a 2.5-inch storage drive in a hard-disk-drive bay, do the following:
1. Prepare your computer. See “Preparing your computer and removing the computer cover” on page 101.
2. Locate the hard disk drive bay in which you want to install or replace a storage drive. See “Internal
drives” on page 37.
3. Remove the storage drive bracket from the hard-disk-drive bay. See step 3 on page 148.
4. Depending on whether you are installing or replacing a storage drive, do one of the following:
• If you are installing a storage drive, go to step 6.
Chapter 9
.
Installing or replacing hardware
151