Lenovo ThinkServer TS150, User Manual And Hardware Maintenance Manual

Page: 87 / 148

To install a memory module, do the following:
1. Prepare your server. See “Preparing your server and removing the server cover” on page 41.
2. Lay the server on its side for easier operation.
3. Locate the memory slot on the system board and remove the memory dummy if necessary.
4. Open the retaining clips and install the memory module into the slot until the retaining clips are
completely closed.
xxx xxxx xxx-xxxxx-x-x-xx-xx
xxxxxxxxxxxxx-xx xx xx xxxx
xxx xxxx xxx-xxxxx-x-x-xx-xx
xxxxxxxxxxxxx-xx xx xx xxxx
xxx xxxx xxx-xxxxx-x-x-xx-xx
xxxxxxxxxxxxx-xx xx xx
xxxx
xxx xxxx xxx-xxxxx-x-x-xx-xx
xxxxxxxxxxxxx-xx xx xx
xxxx
1 2
Figure 60. Installing the memory module
PCIe card
This topic provides instructions on how to install or remove a PCIe card, such as a graphic card, a RAID
card, an Ethernet card, and any other supported PCIe cards. Depending on the specific type, the PCIe card
might look different from the illustrations in this topic.
Note: The PCIe card is extremely sensitive to ESD. Ensure that you read and understand “Handling
static-sensitive devices” on page 40 first and carefully perform the operation.
• “Removing a PCIe card” on page 73
• “Installing a PCIe card” on page 74
Removing a PCIe card
To remove a PCIe card, do the following:
1. Prepare your server. See “Preparing your server and removing the server cover” on page 41.
2. Locate the PCIe card to be removed. For PCIe slot locations, see “System board components” on
page 20.
Chapter 5
.
Replacing hardware
73