Lenovo ThinkServer TS150, User Manual And Hardware Maintenance Manual

Page: 91 / 148

2. Locate the Lenovo ThinkServer RAID 520i PCIe Adapter. See “Server components” on page 17.
3. Touch the static-protective package that contains the RAID 520i key to any unpainted surface on the
outside of the server. Then, take the RAID 520i key out of the package.
Note: Carefully handle the RAID 520i key by its edges.
4. Insert the RAID 520i key into the J3 connector on the Lenovo ThinkServer RAID 520i PCIe Adapter.
Ensure that the RAID 520i key is securely seated on the RAID card.
Note: If necessary, remove the RAID card first for easier operation. Then, reinstall the RAID card.
See “PCIe card” on page 73.
Figure 66. Installing the RAID 520i key
After installing the RAID 520i key, you might need to configure RAID to activate RAID 5 for your server. Back
up your data before you begin to avoid any data loss due to a RAID configuration change. For information
about configuring hardware RAID, refer to the
MegaRAID SAS Software User Guide . This guide is available
on the Lenovo Support Web site at:
http://www.lenovo.com/support
Front USB assembly
• “Removing the front USB assembly” on page 77
• “Installing the front USB assembly” on page 78
Removing the front USB assembly
To remove the front USB assembly, do the following:
1. Prepare your server. See “Preparing your server and removing the server cover” on page 41.
2. Remove the front bezel. See “Removing the front bezel” on page 42.
3. Locate the front USB assembly. See “Server components” on page 17.
4. Disconnect the front USB assembly cable.
Chapter 5
.
Replacing hardware
77