Lenovo ThinkServer TS150, User Manual And Hardware Maintenance Manual

Page: 67 / 148

7. Connect cables to the tape drive.
1
3
2
4
5 6
7
Figure 26. Connecting cables to the tape drive
Cable
From the system board To the tape drive
1-to-3 power cable
1
or
2
4-pin power connector
7
SATA power connector on the power cable of
the tape drive
Note: The tape drive comes with a power cable that
is connected to the power connector
5
.
Signal cable
3
or
4
USB 2.0 connector
6
Signal connector on the tape drive
Note: The 1-to-3 power cable provides three SATA power connectors 1 , 2 , and 3 . You can connect
any one of the SATA connectors to the power cable of the tape drive.
2
1
3
Storage drive in drive bay 1
Drive bay 1 of your server supports a 2.5-inch/3.5-inch hard disk drive or 2.5-inch solid-state drive. For
information about drive bays and installation rules, see “Internal drives” on page 44.
• “Removing a storage drive from drive bay 1” on page 53
• “Installing a storage drive into drive bay 1” on page 54
Removing a storage drive from drive bay 1
To remove a storage drive from drive bay 1, do the following:
1. Prepare your server. See “Preparing your server and removing the server cover” on page 41.
2. Disconnect the signal cable and power cable from the drive.
Chapter 5
.
Replacing hardware
53