Lenord, Bauer GEL 8310, Operating Manual, Page: 62 / 226

F
UNCTIONAL
D
ESCRIPTIONS
4.7 Correction
VALUE
4-23
8310/8610-8
4.7 Correction value
To compensate cutting losses or tool wear, a positive or negative value can be
preset by which each nominal position or nominal length will be corrected
taking the sign into account. This applies to the system of absolute dimensions
(storage location 3/44=0) as well as the system of incremental dimensions
(storage location 3/44
≠
0):
a) absolute dimensions, positions
target position = programmed nominal po correction value
b) absolute dimensions, lengths (floating zero processing)
target position = previous nominal position/ programmed correction value
c) incremental dimensions
counter value at start set to: - correction value (- residual value),
target position = programmed nominal length
The correction value is programmed at storage location 3/6, either in the
machine parameters programming mode or directly in the reset state of the
automatic mode (precondition: storage location 3/7 = 1 [»active«]).
Direct entry of a correction value:
•
Press the
%+3
key combination resp. the
V
key (GEL 8610)
•
Enter the axis number and confirm with
;
•
Enter the correction value (display A) and confirm with
;
The input value becomes active with the next start signal.
It is also possible to preset the correction value via an optional data input
module (refer to storage location 3/76 in appendix A and section 4.10.1).