Lenord, Bauer GEL 8310, Operating Manual, Page: 172 / 226

A-38 S
TORAGE LOCATIONS FOR MACHINE PARAMETERS
8310/8610-8
3
71
72
Pos. min
Pos. max
Minimum position value
Maximum position value
These two values are the limits for the input monitoring within the programming
mode of nominal values or for the direct entry (e.g. reference measure).
Additionally, they fix the maximum positioning range if the function software limit
switch is activated (refer to storage location 3/73)
condition:
Pos. min < Pos. max
exception: Pos. min = Pos. max = 0
In this case, the input monitoring and software limit switch function are disabled.
An error message is issued if the entered nominal value is too small or too big
(refer to section 4.11.1).
For rotary table positioning (refer to storage location 3/8), Pos.
min/max are preset
internally (Pos. min = 0, Pos. max = programmed counting range).
XXXXXXXX
max. digits incl. sign (-) and decimal point; value in actual
measuring units
3 73
SWswitch Software limit switches
If the actual position is above or below the value programmed at storage locations
3/71 and 3/72, the drive is stopped and the
/fault signal is output (High
→
Low
change). The drive can then be moved only in the opposite direction (refer to
section 4.11.1).
For rotary table positioning (refer to storage location 3/8), the limit switch function is
deactivated internally; this also applies if »Pos.
min« = »Pos. max« = 0 has been
programmed (refer to storage location 3/71/72 ) .
0 inactive limit switch function is disabled
1 pos.
monitoring of the actual position during moving
2
d
start
as above, however:
When starting a sentence, it is checked if the newly se-
lected nominal position (e.g. nominal position of the pre-
vious sentence plus length of the new sentence) is still
within the admissible range. If this is not the case, the start
will not be effected and the limit switch will trigger