Lenord, Bauer GEL 8310, Operating Manual, Page: 128 / 226

M
OUNTING INSTRUCTIONS
7.3 Replacing modules
7-5
8310/8610-8
devices with certification devices without certification
✔
Pull out the metal frame with
mounted power supply card
✔
Pull out the desired module
✔
Pull out the desired module
preferably grasping one of the
(still) plugged terminal strips
Due to the compact construction, it may be possible that a card is jamming
slightly. If this is the case, press the card next to it slightly aside or also pull it
out (partially).
✔
Unplug the terminal strips still
being plugged on the module
All terminal strips are coded and
clearly labelled (see appendix B),
so that they cannot be confused
later on.
7.3.2 Assembly
✔
Insert the module in the guiding rails and push it in
The Controller housing contains each 2 adjacent guiding rails. Both power
and P1 modules (see Fig. 1) are to be inserted into the left guiding rails. All
other modules are to be inserted into the right rails (see also appendix B
under ‘Module arrangement …’).
If a module strucks or blocks during insertion press the module next to it
slightly aside or pull it out partially so that both modules can be pushed in
together.
Special notice for module P1 with optional memory card:
Due to the guide frame for the memory card mounted on the front panel,
the module might abut against this frame. In this case press the card
slightly to the left (using a flat tool) so that it can pass the frame on the left.