Spirit User Manual
- 31 -
SmartCenter Page
Under SmartCenter mode the job will be started after the system positions the pen carriage at the
center position between two points indicated by the user. There are two ways to activate the
SmartCenter mode, either through driver or direct from control panel.
Enter SmartCenter page and we can move the pen carriage by hand and press enter to save the
positions indicated by the red pointer. After both points are set, the pen carriage will move to the
Center of the two entered points and the job will begin.
Carriage / Work Table Adjustment Page
Relevant Buttons
Function
F1 (Back)
Back to previous page
F2 (Reset)
Reset all saved positions
F4 (Save)
Save current lens carriage position
U
/
V
Directional
Manually adjust the Y-axis position of the laser
carriage
Y
/
Z
Directional
Manually adjust the X-axis position of the laser
carriage
Start / Stop
Back to Main Work Page
Auto Focus
Initiate the auto focus function
▲
/
▼
Manual Focus Buttons
Manually adjust the height of the work table (Z-
axis)
Main Work Page
SmartCenter Page
Press
F3
☼
navigating to this page:
