- 105 -
Spirit GE User Manual
4)
Please assembling back after the sponge already dried.
Chapter IX - Basic Troubleshooting
Quality Problems
z
Check focal length setting under F4 function key-> Machine Setting-> Set Focus Lens to see if it
matches the type of the lens installed.
z
Check if the focal Lens is installed correctly or if focal Lens is not fixed properly.
z
Check if it is caused by the debris or dust builds up in the bearing tracks or x rail.
z
Check if it is caused from the damaged or dirty focal lens and mirror 4 in the laser carriage which can
not deliver the laser beam effectively.
Non-operational Problems
z
Laser beam does not generate
1. If the red alignment beam is not revealed, the laser beam is misalignment.
Adjust reflection mirrors for exact focus.
2. If the red alignment beam is revealed, please check the driver power. The laser power may be
too low to be detected. Please increase the percentage setting of the Laser Power from the
software driver or the control panel.
3. Please check if the laser power connector is loose.
4. For safety purpose, the laser beam will not be generated when the top or front door is opened
unless you short the connector of the magnetic switches.
5. Check water level or temperature of water cooler for 50W and 100W engraver. If over-heated,
laser beam will shut down automatically.
NOTE:
Unplug the machine before examining the mirrors, lens, motion system or any other part of the
laser system.
