- 100 -
Spirit GE User Manual
5) Wait for all cleaning residue to dry completely before plugging in and operating the Spirit GE.
CAUTION
•
Never pour or spray alcohol or acetone directly to the working table.
•
Oil, alcohol and acetone can cause fires or smoke build-up if improperly used.
8.2.3 Lubrication of the X / Y Rails
In order to keep the motion system running smoothly, the X / Y rails of the motion system will need
lubrication on a semi-regular basis. Use a small amount of light grade machine oil or PS2 grease to a
paper or cotton towel and apply to the rails.
You can purchase PS2 grease from NSK dealers worldwide. Please visit
http://www.nsk.com/eng/company/network/index.html
for additional information.
NOTE
•
Always clean and lubricate the rails after working with materials that produce
lots of debris (such as wood).
•
Too much oil or PS2 grease applied to the X / Y rails will accelerate the build up
of debris.
8.3 Cleaning the Optics System
8.3.1 Removing the Mirrors
We recommend you check the mirrors once or twice a week to see if they require cleaning. If any
debris or smoke residue is present, use the following steps to clean them.
NOTE
•
It is highly recommended you remove, clean and replace each mirror
one at a
time
!
•
Refer to section 8.3.2 on how to clean the mirrors.
The following section will detail how to access and remove each of the four mirrors found on the
LaserPro Spirit GE for cleaning.
Mirror 1
This mirror is located inside the bottom left access panel of the LaserPro Spirit GE.
