- 99 -
Spirit GE User Manual
2) Manually lock the SmartLID via the two sliding locks found on each side of the metal
support rails by sliding them towards you into the locked position (as shown in the picture
below).
WARNING
Anytime you have the SmartLID open, always make sure you have properly
engaged the SmartLID manual locks on both sides of the metal support
rails. Failure to do so may pose a crush risk if any part of your body is
within the vicinity of the work area.
Closing the SmartLID:
To properly close the SmartLID after you have finished accessing the worktable or motion system,
please follow these steps:
1) Disengage both of the sliding locks found on each side of the metal support rails by
sliding them away from you into the unlock position.
2) Push the SmartLID away from you to the maximum position to disengage the latch
(indicated by a small click) and gently shut the SmartLID.
8.2.2 Cleaning the Worktable and Motion System
Clean the working table and the motion system on a frequent basis through the following steps:
1) Turn the power off and unplug the Spirit GE before cleaning.
2) Use a vacuum cleaner with a flexible nozzle to remove dust and debris from the worktable and
motion system.
3) Apply small amounts of all-purpose cleaner, alcohol, or acetone to a paper or cotton towel to
clean the working table.
4) Apply a soap solution, all-purpose cleaner, or alcohol to a paper or cotton towel to wipe down the
rails of the motion system.
SmartLID Sliding Lock
