![background image](http://html2.mh-extra.com/html/landice/l7-club/l7-club_service-manual_3548044093.webp)
Elevation Assembly
Repair Procedures
93
7.23. Elevation Assembly
1. Remove the motor cover.
2. Remove the elevation motor as outlined in “Elevation Motor” on page
82.
3. Block the treadmill up on a stable platform such as two 4” x 4” x 36” pieces of wood as shown below.
Figure 7-29.
Elevation Assembly
4. Place a block beneath the elevation assembly to prevent it from falling during removal.
5. Remove the screws and lock washers from the bearing blocks and lower the elevation assembly to the block.
6. Installation is the reverse of removal.
7. Remove the bearing blocks and remove the elevation assembly.
7.24. Clevis Mount
1. Unplug the power cord.
2. Remove the motor cover.
3. Remove all weight from the elevation assembly by placing a suitably strong object under the under motor pan,
such as a piece of 4” x 4” lumber so that the wheels are off the floor.
4. Remove the three screws securing the Clevis mount to the motor pan from beneath as shown in Figure 7-30.
Wooden
supports
Bearing
Block
Screw and Lock Washer
Elevation
Assembly
Summary of Contents for L7 Club
