![background image](http://html2.mh-extra.com/html/landice/l7-club/l7-club_service-manual_3548044074.webp)
Repair Procedures
Speed Sensor
74
7.8.
Speed Sensor
Tools required
• ½ inch socket wrench
• 7/16 & ¼ inch socket
• Straight blade screwdriver
1. Loosen and remove the two 7/16” nuts holding the plastic cover located on the back of the drive motor.
Figure 7-9.
Speed Sensor Cover Hardware
2. Remove the plastic cover from the drive motor.
3. Loosen and remove the ¼” set screw holding the black round speed wheel as shown in the following figure.
Figure 7-10.
Speed Sensor Speed Wheel
4. Remove the speed wheel.
5. Remove the speed sensor by using a screwdriver to carefully pry the clips holding the sensor just far enough to
remove the speed sensor. Use care to avoid breaking the clips.
Figure 7-11.
Speed Sensor Mounting Clips
6. To install the new sensor, align the sensor with the alignment pole on the plastic mount on the drive motor to the
sensor alignment hole and push the sensor on the clip.
7. After installing the speed sensor, follow steps 1 through 4 in reverse order to reassemble.
Cover Screws
Sensor Cover
Nut
Speed Wheel
Speed Sensor
Clips
Summary of Contents for L7 Club
