![background image](http://html2.mh-extra.com/html/landice/l7-club/l7-club_service-manual_3548044032.webp)
Adjustments
Drive Belt Tension
32
Figure 5-2.
Drive Belt Tension Check
If it does not easily twist to 45°, follow Drive Belt Tensioning procedure.
1. Remove motor cover.
2. Elevate treadmill to 15%.
3. Locate drive belt tensioning nut on bottom of motor pan.
4. Tighten or loosen nut as necessary.
5. Set the treadmill to run at 2mph and walk on treadbelt.
• If the drive belt is moving the front roller with no slippage then drive belt is correctly tensioned. Otherwise,
tighten belt by tightening the tensioning nut, as shown in the following figure, only until it stops slipping. This
rotates the drive motor saddle, thus tightening the belt. The foam block provides “spring” against the belt tension
created by the saddle.
45°
Summary of Contents for L7 Club
