![background image](http://html2.mh-extra.com/html/landice/l7-club/l7-club_service-manual_3548044089.webp)
Drive Roller
Repair Procedures
89
Figure 7-24.
Drive Roller Screw (same for left side)
11. Angle the roller and slide the front roller out from inside the treadbelt.
Note:
Use the drive belt as a handle for removing the roller by wrapping it around the drive roller pulley in the following step.
12. Now that there is slack in the treadbelt, remove the drive roller.
13. Installation is the reverse of removal with the following directions for the felt washers that prevent the deck from
banging against the side frame covers:
• L7:
•Regular Treadbelt: Front two posts: One gray (thick) topped by one white (thin). Remaining Posts: One gray
each.
•Ortho Treadbelt: All posts get one gray (thick) topped by one white (thin) each.
• L8 and L9: All posts get one gray (thick) topped by one white (thin) each.
14. Adjust the tension of the treadbelt as outlined in “Treadbelt Tensioning” on page
33.
15. Adjust drive belt tension as outlined in “Drive Belt Tension” on page
31.
16. Adjust the treadbelt tacking as outlined in “Treadbelt Tracking” on page
35.
Felt washer on
deck post
Roller bolt
Summary of Contents for L7 Club
