![background image](http://html2.mh-extra.com/html/landice/l7-club/l7-club_service-manual_3548044003.webp)
Grounding Instructions
3
Grounding Instrctions
Grounding Instructions
This product must be grounded. If it should malfunction or break down, grounding provides a path of least
resistance for electric current to reduce the risk of electric shock. The treadmill is equipped with a cord having an
equipment grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is
properly installed and grounded in accordance with all local codes and ordinances.
• 120–Volt Treadmills
Treadmills marked 120 VAC are intended for use with a grounding plug in a nominal 120-volt circuit. Ensure the
treadmill power cord is connected to an outlet having the same configuration as the plug. No adapter should be
used with 120 VAC treadmills.
• 200 – 250-Volt Treadmills
Treadmills marked 200-250 VAC are intended for use on a circuit having a nominal rating greater than 120V and are
factory-equipped with a specific power cord and plug to permit connection to a proper electrical circuit. Ensure the
treadmill power cord is connected to an outlet having the same configuration as the plug. No adapter should be
used with 200 – 250 VAC treadmills.
If the treadmill must be configured for use on a different type of electrical circuit, qualified service personnel should
make the proper connection.
It is intended that a qualified, trained technician work on this treadmill
Read all instructions before using the treadmill.
• Familiarize yourself with this manual. Be sure you understand control panel operation before using the treadmill.
WARNING
Failure to observe the following warning statements can result in serious injury!
• Do not use this product without first consulting your doctor if you suffer from any illness, condition,
or disability that affects your ability to run, walk or exercise.
• Do not use this product without supervision present if you are suffering from any illness, condition,
or disability which affects your ability to run, walk or exercise. Failure to do so can result in serious
injury should you fall while the treadbelt is moving.
• Failure to leave ample clearance around the treadmill could cause you to be trapped between the
treadmill and a wall if you fall, resulting in burns or other serious injury from the moving treadbelt.
Allow a minimum clearance of 18 inches (46 cm) on each side of the treadmill. Allow a
minimum clearance of 6 feet (183 cm) at the rear of the treadmill.
• Never stand on the treadbelt when starting the treadmill. A sudden start could cause you to lose
your balance. Always begin by placing your feet on the side traction strips, straddling the treadbelt,
before turning the treadmill on.
• Always wear the safety lanyard clip securely on your clothing while exercising. Failure to do so can
result in severe injuries should you accidentally fall while exercising.
• Test the emergency stop safety lanyard regularly by pulling on the cord and ensuring that the
treadbelt comes to a complete stop when key is pulled.
• Familiarize yourself with this manual. Be sure you understand operation of the treadmill before use.
• Always follow basic safety precautions when using an electrical appliance.
WARNING
Connect treadmill to a properly grounded, dedicated electrical outlet only. See the
following Grounding Instructions.
WARNING
Do not plug treadmill into a surge suppressor or Ground Fault Interrupt (GFI) outlet.
Summary of Contents for L7 Club
