![background image](http://html2.mh-extra.com/html/landice/l7-club/l7-club_service-manual_3548044078.webp)
Repair Procedures
Capacitor
78
7.12. Capacitor
Note:
This applies to Club models only that use the SCR MCB.
1. Unplug the treadmill from its outlet.
2. Remove the motor cover.
3. Disconnect all wires from the capacitor.
4. Connect the replacement choke as outlined in Table 7-5.
7.13. Drive Motor
1. Elevate treadmill to 15%. Unplug power cord.
2. Remove the motor cover (See “Motor Cover” on page
73).
3. Disconnect the motor’s white, green, and black wires from the motor control board.
4. If required remove green ground wire from frame.
5. Remove drive belt tension adjustment bolt by removing nut. Nut is located on bottom of motor pan as shown in
the following figure.
Table
7-5
Capacitor Connections
Contact/Connector
Destination
White wire
to SCR
Black wire
to SCR
Purple wire
to Choke
Resistor
both Poles of the Capacitor
Summary of Contents for L7 Club
