Lamtec ETAMATIC, Manual, Page: 50 / 136

49
6 O2-Control
No FMS ETA Short Text Description Min Max Default
900 0 0 O2 TZ - Dead time reduction for O
2
controlled system at full load 0 5 3
Reduces dead time at the burner’s high firing-rate. With
this parameter, you can adjust the dead time depending
on the firing-rate. Because of the higher gas speeds, the
dead time is reduced at the high firing-rate. The factory
setting is the reduction in the dead time of 3 seconds.
901 1 1 O2NeutrA Correction value output when O
2
trim is deactivated 0 1000 400
Correction value is displayed at deactivated O
2
trim.

Fuel 1

(from 5.0 on):
and P 847 = 2,3 or 4:
0 = the last received value is permanently valid

1..65535 = Time-out in seconds after P 901 / P 902 is
active.
902 1 1 O2NeutrB Correction value output when O
2
trim is deactivated. 0 1000 400
Correction value is displayed at deactivated O
2
trim.

Fuel 1

(from 5.0 on):
at P 7 = 2 (dec) and P 847 = 2, 3 or 4:

O
2
trim / CO controller slave / correction 1 via LSB

0 = the last received value is permanent valid

1..65535 = Time-out in seconds after P 901 / P 902 is
active.
917 1 1 LftmKorA Air deficiency correction value fuel A 0 999 300
Air deficiency correction value for fuel 1
918 1 1 LftmKorB Air deficiency correction for fuel B see P 917 0 999 300