Section 2 NAMES OF PARTS
(4) Optional units
●
Finisher
1
Sort tray
(When you are Sort copying or Group copying, finished copies will be ejected onto this tray. The Sort tray will automatically lower as the number of
copies increases and will be raised when the number of copies is minimal.)
2
Non-sort tray
(When you are copying in the Non-sort mode, finished copies will be ejected onto the Non-sort tray. The maximum number of copies that can be
stored on the Non-sort tray will differ depending on the size of copy paper that is being used. See page 9-5.)
3
Finisher release button
(Hold this button down when you want to separate the Finisher from the copier.)
4
Front cover
(Open this cover if paper misfeeds inside the Finisher or when replenishing staples in the stapler holders.)
5
Front cover handle
(Use this handle to open the front cover.)
6
Upper cover
(Open this cover if paper misfeeds during ejection onto the Non-sort tray.)
7
Scrap hole-punch tank
(The scraps left over from the hole puncher are collected here.)
8
Scrap hole-punch tank knobs
(Use these knobs to remove the scrap hole-punch tank.)
9
Internal tray
0
Internal tray handle
(Use this handle to pull out the internal tray if paper misfeeds or another problem occurs.)
!
Conveyor knob
(Use this knob if paper misfeeds between the internal tray and the Sort tray.)
@
Conveyor guide handle A
(Use this handle if paper misfeeds.)
#
Conveyor guide handle B
(Use this handle if paper misfeeds.)
$
Stapling Unit handle
(Use this handle when removing the staple holder.)
%
Staple holder release lever
(Use this lever when removing the staple cartridge.)
^
Staple holder
(Insert staples here.)
2-5
Summary of Contents for KM-6230
Page 12: ...Section 2 NAMES OF PARTS Section 2 NAMES OF PARTS 2 1 ...
Page 154: ...12 4 ...
Page 158: ...12 8 A ...