6-8
Repair manual KTM LC8
Art.-Nr
. 3.206.009-E
Generator cover
– Mount dowel pins on the engine case and put a new gasket in place.
Position the generator cover and tighten the generator cover bolts to
10 Nm (see illustration for bolt lengths).
– Mount the chain sprocket with the lock washer and tighten the nut
1
to 60 Nm.
Timing chain and balancing weight
– Screw the output-end timing chain tensioning rail
2
. Apply Loctite
243 to the bolt and tighten to 20 Nm.
!
CAUTION
!
M
AKE SURE NO LOCTITE THREAD ADHESIVE IS ON THE PIVOT AREA OF THE BOLT
.
THIS
COULD CAUSE THE TIMING CHAIN TENSIONING RAIL TO BLOCK AND BREAK
.
– Insert the woodruff key for the chain sprocket in the shaft groove and
push the chain sprocket onto the balancer shaft. Fit the timing chain
(pay attention to the running direction if the chain has already been
used).
– Insert the woodruff key for the balancing weight in the shaft groove
and mount the balancing weight
3
with the aperture
4
towards the
front.
M6x30
M6x30
M6x30
M6x35
M6x35
M6x30
M6x30
M6x30
M6x30
1
2
3
4