6-21
NOTE:
– Check the position of the camshafts on cylinder front in the TDC
position of cylinder rear. The cams on the exhaust camshaft
1
will
point towards the inside and rest against the bucket tappet. The cams
on the intake camshaft
2
also point towards the inside, the bucket
tappets are not actuated. If the camshafts are in a different position,
check the timing and reset.
– Check valve clearance (see page 12-7)
– Remove the crankshaft blocking tool
3
. Insert the case bolt (M8x60)
with a new sealing washer and tighten to 10 Nm.
– Screw the plug
4
into the generator cover.
Starter motor
– Insert the starter motor into the opening in the case with a new
O-ring (greased). Insert both bolts
5
(M6x25) and tighten to
10 Nm.
1
2
3
4
5
5
