3-9
– Place the chain over the pinion and rear sprocket, lift the rear wheel
and slide the wheel spindle through.
– Press the rear wheel towards the front to apply the chain tensioner
1
and tighten the nut on the wheel spindle to 110 Nm.
– Actuate the foot brake pedal to apply the brake shoes against the
brake disk.
– Check the chain tension, see owners manual, page 25.
– Mount the chain securing guide and the chain roller.
– Insert the locking pin in the pushrod and mount the clutch slave
cylinder
2
. Screw on the chainguard
3
.
– Position the side stand and tighten the two bolts and the nut
4
to 45 Nm.
– Mount the side stand switch
5
and fasten the cable with the cable
clips.
– Carefully install the oil line, mount the oil tank and tighten the fixing
bolts
6
.
– Connect the return line
7
to the oil tank and mount the spring-
loaded band-type clamp with the special pliers 600.29.057.100.
– Attach the oil lines from the oil tank to the valve covers
8
(special
pliers 600.29.057.100).
– Mount both oil lines on the oil terminal
9
with new O-rings, insert
the bolts (M6x20) in the retaining brackets
bk
and tighten to 10 Nm.
6
2
3
4
7
8
9
6
5
10
10
1
1