KTM 690 Enduro R 2018, Repair Manual

Page: 133 / 311

—
Detach
spring
bar
@.
—
Remove
headlight
bulb
@.
—
Insert
a
new
headlight
bulb into the
headlight housing.
Headlight
(H4 / socket P43t) (~~
p.
243)
—
Fix
the
headlight
bulb in the
headlight using
the
spring
bar.
Mount the
protection
cap.
Plug in the connector.
Finishing
work
—
Install the
headlight
mask with the
headlight. (°—
p.
129)
—
Check the
headlight setting.
(=
p.
127)
Note
Damage
to
reflector Grease
on
the
reflector reduces the
brightness.
Grease
on
the bulb will evaporate due
to
the heat and be
deposited
on
the reflector.
-—
Clean and degrease
the bulbs before
mounting.
—
Do
not
touch the bulbs with
your bare
hands.
Main work
(690 Enduro R EU)
—
Remove the
screw on
the
rear
of
the turn
signal housing.
—
Tilt
headlamp
diffuser
@
forward
carefully
and takeit off.
—
Lightly
squeeze orange cap
€ %
in
the
area
of
the
holding
lugs
and take
it off.
—
Press the
turn
signal
bulb
lightly
into the socket,
turn
it
counterclockwise by
about
30°,
and take
it
out
of
the
socket.
e
Info
Do
not touch
the reflector with your
fingers,
and
keep it free from grease.
—
Press the
new
turn
signal
bulb
carefully
into the socket
and turn it clockwise until it
stops.
Turn
signal (R1LOW
/ socket
BA15s) (""
p.
243)
—
Mount the orange cap.
—
Position
the
diffuser.
—
Insert the
screw and
first
turn
counterclockwise until it
engages
in the thread with
a
small
jerk. Tighten
the
screw
lightly.
131