KTM 690 Enduro R 2018, Repair Manual

Page: 140 / 311

Plug in both plugs of the ignition
coils.
&
Thecable
with the white marking is connected to the
outer
ignition
coil.
Plug
in the connector
of
the
engine
coolant
temperature
sen-
sor
@
Connect
plug-in
connectors
©
of
the gear
position
sensor,
crankshaft
position
sensor,
and alternator.
Position the throttle valve body.
Position and
tighten
hose
clip
@.
Position the electrical connection
on
the starter
motor.
Mount
and
tighten
screw
@.
Mount the
protection
cap.
Guideline
Screw,
cable
on
M5 3 Nm
(2.2 Ibf ft)
starter motor
Position the ground wire
on
the starter motor. Mount and
tighten
screw
@.
Guideline
Screw,
starter
M6 10 Nm (7.4 Ibf ft)
motor
Loctite®243TM
Insert the clutch
push
rod.
Position the clutch slave
cylinder
with the gasket.
Mountand
tighten
screws
®.
Guideline
Screw,
clutch M6x20 10 Nm (7.4 Ibf ft)
slave
cylinder
Loctite®243TM
Screw,
clutch M6x35 10 Nm
(7.4
Ibf
ft)
slave
cylinder
Loctite®243TM
Secure the cable with the cable ties
®.
138