KTM 690 Enduro R 2018, Repair Manual

Page: 159 / 311

After
the
section of
the
engine
case
has cooled, check
that the
bearings
are
firmly
seated.
e
Info
i
If the
bearings
are
not
firmly
seated after
cooling, it
is
likely
that they will rotate in the
engine
case
when
warm.
In this case, the
engine
case
must
be renewed.
Position all
bearing
retainers. Mount and
tighten
the
screws.
Guideline
Locking
screw
M5 6 Nm (4.4 Ibf ft)
for
bearing
Loctite®243TM
Mountand
tighten oil
nozzle
@.
Guideline
Oil jet, piston M6x0.75
4 Nm
(3 Ibf ft)
cooling
Loctite®243TM
Mountand
tighten
oil nozzle
Q.
Guideline
Oil nozzle for M4 2 Nm (1.5 Ibf ft)
conrod
bearing
Loctite®243TM
lubrication
Blow compressedair through
all
oil channels and check that
they
are
clear.
Position
cover
plate
@.
Mount and
tighten
the
screws.
Guideline
Screw,
cover
plate
for
|
M5 6 Nm
(4.4
Ibf ft)
oil return line
Reinstall the dowels.
17.4.2
Working
on
the left
section of
the
engine
case
305646-10
Removeall dowels.
Remove oil nozzle
@.
Remove shaft seal
rings
of the countershaft
Qe
and
8
of the
shift shaft.
e
Info
Shaft seal
ring
oO
of the crankshaft cannot be removed
before the crankshaft bearing.
Unscrew the membrane support
plate
8
and
remove
it
together with
membrane
6.
Remove
screws
@
with the washer.
157