KTM 690 Enduro R 2018, Repair Manual

Page: 129 / 311

202058-10
Main work
Unplug
connector
ED from the combination instrument.
Unlock
pin
18
@
and
remove
it
from
connector ED.
Plug
connector ED
into
the combination instrument.
Switch
on
the
ignition by
turning
the
ignition key
to
position
ON ©).
Press the MODE button
repeatedly
until the TRIP 1
display
mode
is active.
Press and
hold
the
MODE
button
for 10
seconds.
& The wheel circumference is displayed in millimeters.
Increasing
the wheel
circumference
—
Press the MODE button
@.
Reducing
the wheel circumference
—
Press the SET button
@.
Keep
the MODE button and the SET button
pressed simultane-
ously.
“
The
settings
are
saved and the
Setup
menu
is closed.
Switch off the
ignition by
turning
the
ignition key
to
position OFF &.
Unplug
connector ED
from the combination instrument.
Connect
pin
18 to connector ED.
Plug
connector
ED into the combination instrument.
Finishing
work
Install the
headlight
mask with the
headlight. (~~
p.
129)
Checkthe
headlight setting.
(~~
p.
127)
4
400726-10
Position
the
vehicle upright
on a
horizontal surface in front of
a
light
wall and make
a
mark at the
height of
the center
of
the
low beam headlight.
Make another mark
at
a
distance
@
underthe first mark.
Guideline
|
Distance
@
5
cm
(2 in)
Position the vehicle vertically
at
a
distance
®
away
from the
wall.
Guideline
|
Distance
@
|
5
m
(16 ft)
The
rider, with
luggage
and passenger
if
applicable,
now
mounts
the motorcycle.
Switch
on
the low beam.
Check the
headlight
setting.
The
light-dark boundary
must
lie
exactly
on
the lower
mark when the
motorcycle
is
ready
to
operate
with the
rider mounted
along
with
any
luggage
and
a passenger
if
applicable.
»
If the
boundary
between
light
and dark does not meet
specifications:
127