KTM 690 Enduro R 2018, Repair Manual

Page: 161 / 311

Guideline
Oil
jet, piston
M6x0.75 4 Nm
(3
Ibf
ft)
cooling
Loctite®243TM
—
Mount the dowels.
—
Blow compressedair
through
all oil channels and check that
they
are
clear.
—
Measure
the
spring
length
of
the
oil
pressure
regulator
valve.
Oil pressure
regulator
valve
-
|
25.36
mm
(0.9984in)
minimum spring length
»
|f the measured value does
not meet
specifications:
—
Change
the
spring.
—
Check the piston valve for
damage
and
wear.
»
If there is
damage
or wear:
305602-10 —
Replace
the
piston
valve.
—
Lubricate piston valve
©
and
mount
it with pressure
spring
@.
Mountand
tighten
screw
plug
@
with
a new
seal
ring.
Guideline
Oil pressure regulator
|
M12x1.5 20 Nm (14.8 Ibf ft)
valve
plug
—
Position membrane support
plate
eo
with membrane
@.
Mount and
tighten
the
screws.
eal
30554810
Guideline
Screw,
mem-
M3 2 Nm
(1.5
Ibf
ft)
branefixation
Loctite®243TM
e
Info
i
The membrane
support plate is
curved and must
point
away from the membrane.
An
incorrectly
installed membrane support
plate
results
in loss of
performance
and increased oil
consumption
or
leaks.
Do not apply thread locker between the membrane and
the membrane support
plate
since this would impair
their function.
17.4.3. Work
on
the clutch
cover
—
Removetheshaft seal
ring
@P
of the crankshaft.
—
Press in
a new
shaft seal
ring
with the
open
side
facing
inward
until
it stops.
e
Info
Support
the clutch
cover
sufficiently
when
pressing in.
—
Blow compressed air through
the
oil channel and check that it
is clear.
305662-10
159