Safety
9
Pos: 17.1 /Überschriften/Überschriften 1/P-T/Sicherheit @ 0\mod_1195566748646_78.docx @ 635 @ 1 @ 1
3 Safety
Pos: 17.2 /Überschriften/Überschriften 2/U-Z/Verwendungszweck @ 1\mod_1201707246738_78.docx @ 54055 @ 2 @ 1
3.1
Purpose of Use
Pos: 17.3 /BA/Einleitung/Vorsätze/Verwendungszweck X-Disc 620 @ 328\mod_1426600093892_78.docx @ 2513157 @ @ 1
The direct cutting system of the X-Disc 620 series is a header especially for the KRONE forage
harvester BiG X. It is used to cut thin crops growing on the ground.
Pos: 17.4.1 /Überschriften/Überschriften 2/A-E/Bestimmungsgemäßer Gebrauch (alt) @ 0\mod_1196401545090_78.docx @ 7728 @ 2 @ 1
3.2
Intended Use
Pos: 17.4.2 /BA/Einleitung/Bestimmungsgemäßer Gebrauch/Vorsätze/Bestimmungsgemäßer Gebrauch X-Disc @ 12\mod_1224575491250_78.docx @ 151478 @ @ 1
The direct cutting system may be attached only to carrier vehicles for which the relevant adapter
frame is released (observe operating permission of the carrier vehicle). It is built exclusively for
customary use in agricultural work (intended use) - see also Introduction chapter entitled
"Purpose of Use".
Pos: 17.4.3 /BA/Einleitung/Bestimmungsgemäßer Gebrauch/Nicht bestimmungsgemäß @ 103\mod_1332171672294_78.docx @ 940272 @ @ 1
Unauthorised modifications to the machine may have a negative effect on the machine
characteristics or safe and reliable use of the machine or may interfere with proper operation.
Unauthorised modifications shall therefore release the manufacturer of any liability for
consequential damage.
Pos: 17.5 /Überschriften/Überschriften 2/K-O/Nutzungsdauer der Maschine @ 318\mod_1423658430909_78.docx @ 2465744 @ 2 @ 1
3.3
Service life of the machine
Pos: 17.6 /BA/Einleitung/Nutzungsdauer der Maschine_Text @ 318\mod_1423556613022_78.docx @ 2463145 @ @ 1
–
The service life of this machine strongly depends on proper use and maintenance as well as
the operating conditions.
–
Permanent operational readiness as well as long service life of the machine can be
achieved by observing the instructions and notes of these operating instructions.
–
After each season of use, the machine must be checked thoroughly for wear and other
damage.
–
Damaged and worn parts must be replaced before placing the machine into service again.
–
After the machine has been used for five years, carry out full technical inspection of the
machine. According to the results of this inspection, a decision concerning the possibility of
reuse of the machine should be taken.
–
Theoretically, the service life of this machine is unlimited as all worn or damaged parts can
be replaced.
Pos: 17.7 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1